LEGRAND Raritan PX3TS User Manual page 682

Chapter 9: Using the Command Line Interface
config:# authentication radius modify <server_num> sortPositon <position>
config:# authentication radius add 192.168.7.99 chap 1812 1813 10 3
662
Tip: You can add more than one parameters to the command. For example,
"authentication radius modify <server_num> host <host>
authType <rds_type> authPort <auth_port> accountPort
<acct_port> ...".
Variables:
•
<server_num> is the sequential number of the specified server in the
Radius server list.
•
<host> is the new IP address or host name of the Radius server.
•
<rds_type> is one of the Radius authentication types: pap, chap,
msChapV2.
•
<auth_port> is the new authentication port number.
•
<acct_port> is the new accounting port number.
•
<timeout> is the new timeout value in seconds. It ranges between 1 to 10
seconds.
•
<retries> is the new number of retries. It ranges between 0 to 5.
To enter the shared secret:
1. After executing the above Radius command, the system automatically
prompts you to enter the shared secret.
2. Type the secret and press Enter.
3. Re-type the same secret and press Enter.
Example:
Removing an Existing Radius Server
This command removes an existing Radius server from the server list.
config:# authentication radius delete <server_num>
Variables:
•
<server_num> is the sequential number of the specified server in the
Radius server list.