Table of Contents
Advertisement
Push Out Sensor Readings
You can configure the PX3TS to push sensor log to a remote server after a
certain event occurs, including logs of internal sensors, environmental sensors
and actuators.
If you have connected Raritan's asset strips to the PX3TS, you can also
configure the PX3TS to push the data to a server.
Before creating this action, make sure that you have properly defined the
destination servers and the data to be sent on the Data Push page. See
Configuring Data Push Settings
Tip: To send the data at a regular interval, schedule this action. See
an Action
(on page 416). Note that the "Asset management log" is generated
only when there are changes made to any asset strips or asset tags, such as
connection or disconnection events.
Operation:
1.
Choose Device Settings > Event Rules >
2.
Select 'Push out sensor readings' from the Action list.
3.
Select a server or host which receives the data in the Destination field.
▪
If the desired destination is not available yet, go to the Data Push page
to specify it.
Record Snapshots to Webcam Storage
This option allows you to define an action that starts or stops a specific
webcam from taking snapshots.
Per default the snapshots are stored on the PX3TS. See
Locally-Saved Snapshots
It is recommended to specify a remote server to store as many snapshots as
possible. See
Changing Storage Settings
Operation:
1.
Choose Device Settings > Event Rules >
2.
Select 'Record snapshots to webcam storage' from the Action list.
3.
Select a webcam in the Webcam field.
4.
Select the action to perform - 'Start recording' or 'Stop recording.'
If 'Start recording' is selected, adjust the values of the following:
▪
Number of snapshots - the number of snapshots to be taken when the
event occurs.
(on page 438).
(on page 500).
(on page 502).
Chapter 7: Using the Web Interface
Scheduling
.
Viewing and Managing
.
401
Advertisement
Table of Contents
Troubleshooting
