Table of Contents
Advertisement
Chapter 7: Using the Web Interface
492
To reset the device to factory defaults:
1.
Choose Maintenance > Unit Reset >
2.
Type your password and then click Factory Reset to reset the PX3TS to
factory defaults.
3.
A message appears, with a countdown timer showing the remaining time
of the operation. It takes about two minutes to complete.
4.
When the reset is complete, the login page opens.
Tip: If you are not redirected to the login page after the reset is complete, click
the text "this link" in the countdown message.
Alternative:
There are two more methods to reset the device to factory defaults.
•
Use the "mechanical" reset button
•
Perform the CLI command
For details, see
Resetting to Factory Defaults
Note: Device reset will cause CLI communications over an "USB" connection to
be lost. Therefore, re-connect the USB cable after the reset is complete.
Retrieving Software Packages Information
You can check the current firmware version and the information of all open
source packages embedded in the PX3TS through the web interface.
To retrieve the embedded software packages information:
1.
Choose Maintenance > About PDU. A list of open source packages is
displayed.
2.
You can click any link to access related information or download any
software package.
(on page 775).
.
Advertisement
Table of Contents
Troubleshooting
