LEGRAND Raritan PX3TS User Manual page 300

Chapter 7: Using the Web Interface
280
When the PX3TS detects the connection of any listed device, it replaces
'Feature Port' in the menu with that device's name and shows that device's
data/settings instead. See
289), Schroff LHX/SHX (on page 290) and
When no devices are detected, the PX3TS displays the name 'Feature Port" and
the Feature Port page shows the message "No device is currently connected."
Open the Feature Port page by clicking it in the
page, you can enable or disable this port's detection capability, or force it to
show a specific device's data/settings even though no device is detected.
Note: You must enable the LHX/SHX support for the PX3TS to detect the
presence of a supported Schroff
(on page 462).
To configure the feature port:
1. Click on the top-right corner. The Feature Port Setup dialog appears.
2. Click the Detection Mode field, and select one mode.
Mode
Auto
Disabled
Asset Strip,
Raritan asset strips,
LHX 20,
SHX 30,
LHX 40,
Power CIM
Note: 'LHX 20', 'SHX 30', and 'LHX 40' are not available when the support of
LHX/SHX heat exchangers is disabled. See
Asset Strip (on page 281),
Power CIM
Menu
LHX/SHX heat exchanger. See
®
Description
Enable the port to automatically detect the device
connection.
Disable the port's detection capability.
Force the PX3TS to show the selected device's
data/setup page regardless of the physical
connection status.
Miscellaneous
External Beeper (on page
(on page 295).
(on page 176). From this
Miscellaneous
(on page 462).