LEGRAND Raritan PX3TS User Manual page 44

Chapter 3: Initial Installation and Configuration
•
PX3TS 1U back panel RS-232 port:
24
To use the command line interface (CLI) for configuration, establish an RS-232
or USB connection.
To use a web browser for configuration, make a network connection to the
computer. The PX3TS is automatically configured with the following link-local
addressing in any network without DHCP available:
•
https://169.254.x.x (where x is a number)
•
https://pdu.local
See APIPA and Link-Local Addressing
Addressing (on page 6).
Establish one of the following connections to a computer. Ethernet port of
PX3TS must be enabled for the described connection to work properly, which
has been enabled per default.
Direct network connection:
1. Connect one end of a standard network patch cable to the Ethernet port of
the PX3TS.
2. Connect one end of a standard network patch cable to either Ethernet port
of the PX3TS.
3. Connect the other end to a computer's Ethernet port.
4. On the connected computer, launch a web browser to access the PX3TS,
using either link-local addressing: pdu.local or 169.254.x.x. See
page 170).
USB connection:
1. A USB-to-serial driver is required in Windows
connecting the USB cable. See
(on page 850).
2. Connect a USB cable between a computer's USB-A port and the USB-B port
of PX3TS.
3. Perform Initial Network Configuration via CLI
Note: Not all serial-to-USB converters work properly with the PX3TS so
Raritan does not introduce the use of such converters.
Serial connection for "DB9" RS-232 connector on PX3TS:
1. Connect one end of the null-modem DB9 cable to the male "DB9" RS-232
port labeled CONSOLE / MODEM on PX3TS.
•
PX3TS-iX7 1U back panel RS-232 port:
(on page 6).See
. Install this driver before
®
Installing the USB-to-Serial Driver (Optional)
(on page 851).
APIPA and Link-Local
Login (on