Actuator Configuration Commands - LEGRAND Raritan PX3TS User Manual

Chapter 9: Using the Command Line Interface
680

Actuator Configuration Commands

An actuator configuration command begins with actuator. You can configure
the name and location parameters of an individual actuator.
You can configure various parameters for one actuator at a time. See
Multi-Command Syntax
Change the name:
config:# actuator <n> name "<name>"
Set the X coordinate:
config:# actuator <n> xlabel "<coordinate>"
Set the Y coordinate:
config:# actuator <n> ylabel "<coordinate>"
Set the Z coordinate:
config:# actuator <n> zlabel "<z_label>"
Modify the actuator's description:
config:# actuator <n> description "<description>"
Variables:
•
<n> is the ID number assigned to the actuator. The ID number can be
found using the PX3TS web interface or CLI. It is an integer starting at 1.
•
<name> is a string comprising up to 64 ASCII printable characters. The
<name> variable must be enclosed in quotes when it contains spaces.
•
<coordinate> is a string comprising up to 24 ASCII printable characters, and
it must be enclosed in quotes.
•
There are two types of values for the <z_label> variable, depending on the
Z coordinate format you set:
Type Description
Free form <coordinate> is a string comprising up to 24 ASCII
printable characters, and it must be enclosed in
quotes.
Rack units <coordinate> is an integer number in rack units.
Note: To specify the Z coordinate using the rack units, see
Coordinate Format for Environmental Sensors
(on page 695).
Setting the Z
(on page 575).