Tip: To reset ALL active energy counters on the PX3TS, see
To configure inlet thresholds:
Per default, there are pre-defined RMS voltage and current threshold values in
related fields. See
Default Voltage and Current Thresholds
can modify them to meet your needs.
1.
Click the Thresholds title bar at the bottom of the page to display inlet
thresholds.
2.
Click the desired sensor (required), and then click Edit Thresholds.
3.
Make changes as needed.
▪
To enable any threshold, select the corresponding checkbox.
Chapter 7: Using the Web Interface
PDU
(on page 206).
(on page 842). You
219