Initial Network Configuration Via Cli - LEGRAND Raritan PX3TS User Manual

Initial Network Configuration via CLI

Note: If the PX3TS enters the disaster recovery mode when the USB serial driver
is not installed yet, it may be shown as a 'GPS camera' in the Device Manager
on the computer connected to it.
In Linux:
No additional drivers are required, but you must provide the name of the tty
device, which can be found in the output of the "dmesg" after connecting the
PX3TS to the computer. Usually the tty device is "/dev/ttyACM#" or
"/dev/ttyUSB#," where # is an integer number.
For example, if you are using the kermit terminal program, and the tty device is
"/dev/ttyACM0," perform the following commands:
> set line /dev/ttyACM0
> Connect
After the PX3TS is connected to your network, you must provide it with an IP
address and some additional networking information.
This section describes the initial network configuration via a serial RS-232 or
USB connection. To configure the network settings using the web interface, see
Configuring Network Settings
To configure the PX3TS device:
1. On the computer connected to the PX3TS, open a communications
program such as HyperTerminal or PuTTY.
2. Select the appropriate COM port, and set the following port settings:
▪
Bits per second = 115200 (115.2Kbps)
▪
Data bits = 8
▪
Stop bits = 1
▪
Parity = None
▪
Flow control = None
Tip: For a USB connection, you can determine the COM port by choosing
Control Panel > System > Hardware > Device Manager, and locating the
"Dominion PX2 Serial Console" under the Ports group.
3. In the communications program, press Enter to send a carriage return to
the PX3TS.
4. The PX3TS prompts you to log in. Both user name and password are case
sensitive.
Username: admin
a.
b. Default password: raritan (or a new password if you have changed
it).
5. If prompted to change the default password, change or ignore it.
Appendix J: Additional PX3TS Information
(on page 310).
851