Table of Contents
Advertisement
Chapter 5: PDU Linking
86
4.
To return to the PDU page for the master, select the master PDU. Master
number "1" appears in parentheses.
Note: The Switch control is only available when there is at least one link unit in
the chain; otherwise, the page defaults to displaying only the data of the
master PDU.
Re-linking a Link Unit
In PDU Linking, Re-link is a required function when a link unit no longer
recognizes or responds to the master unit, most likely caused when the link
unit has been reset to factory defaults. Resetting to factory defaults causes the
linked unit in the chain to be unreachable, and it would have to be removed
from the chain manually.
If reset to factory defaults, the status of the disassociated link unit will be
displayed on the PDU page as "Access Denied", shown below.
To re-link a link unit:
1.
When you select the link unit in the "Access Denied" status, the Re-link
button displays, as noted above.
2.
To reconnect the link unit in the chain, and to regain full control of the unit,
click Re-link.
Advertisement
Table of Contents
Troubleshooting
