Tftp Requirements; Dhcp Ipv4 Configuration In Windows - LEGRAND Raritan PX3TS User Manual

Appendix D: Bulk Configuration or Firmware Upgrade via DHCP/TFTP

TFTP Requirements

DHCP IPv4 Configuration in Windows

748
To perform bulk configuration or firmware upgrade successfully, your TFTP
server must meet the following requirements:
•
The server is able to work with both IPv4 and IPv6.
In Linux, remove any IPv4 or IPv6 flags from /etc/xinetd.d/tftp.
Note: DHCP will execute the "fwupdate.cfg" commands once for IPv4 and
once for IPv6 respectively if both IPv4 and IPv6 settings are configured
properly in DHCP.
•
All required configuration files are available in the TFTP root directory. See
Bulk Configuration/Upgrade Procedure
If you are going to upload any PX3TS diagnostic file or create a log file in the
TFTP server, the first of the following requirements is also required.
•
The TFTP server supports the write operation, including file creation and
upload.
In Linux, provide the option "-c" for write support.
•
Required for uploading the diagnostic file only - the timeout for file
upload is set to one minute or longer.
For those PX3TS devices using IPv4 addresses, follow this procedure to
configure your DHCP server. The following illustration is based on Microsoft
Windows Server 2012 system.
Required Windows IPv4 settings in DHCP:
1. Add a new vendor class for Raritan's PX3TS under IPv4.
a. Right-click the IPv4 node in DHCP to select Define Vendor Classes.
(on page 747).
®