Device-Specific Settings - LEGRAND Raritan PX3TS User Manual

Appendix J: Additional PX3TS Information

Device-Specific Settings

858
•
Wireless IPv4 / IPv6 settings:
Commands for wireless IP settings are identical to those for wired networking.
Just replace the variable <ETH> with the word 'wireless'. The following
illustrates a few examples.
To set or Use this command
enable
network ipv4 interface WIRELESS
IPv4
configMethod <mode>
configuration
method
<mode> = dhcp (default) or static
network ipv6 interface WIRELESS
IPv6
configMethod <mode>
configuration
method
<mode> = automatic (default) or static
To verify network settings:
After exiting the above configuration mode and the # prompt re-appears, type
this command to verify all network settings.
▪
show network
The IP address configured may take seconds to take effect.
A bulk configuration file will NOT contain any device-specific information like
the following list.
For further information, simply open the built-in bulk profile for a detailed list
of 'excluded' settings.
•
Device name
•
SNMP system name, contact and location
•
Part of network settings (IP address, gateway, netmask and so on)
•
Device logs
•
Names, states and values of environmental sensors and actuators
•
TLS certificate
•
Server monitoring entries
•
Asset strip names and rack unit names
•
Outlet names and states