LEGRAND Raritan PX3TS User Manual page 344

Chapter 7: Using the Web Interface
324
Static Route Examples
This section describes two static route examples: IPv4 and IPv6. Both examples
assume that two network interface controllers (NIC) have been installed in one
network server, leading to two available subnets, and IP forwarding has been
enabled. All of the NICs and PX3TS devices in the examples use static IP
addresses.
Most of local multiple networks are not directly reachable and require the use
of a gateway. Therefore, we will select Gateway in the following examples. If
your local multiple networks are directly reachable, you should select Interface
rather than Gateway.
Note: If Interface is selected, you should select an interface name instead of
entering an IP address. See
IPv4 example:
•
Your PX3TS: 192.168.100.64
•
Two NICs: 192.168.200.75 and 192.168.100.88
•
Two networks: 192.168.200.0 and 192.168.100.0
•
Prefix length: 24
Interface Names (on page 327).