Canceling The Power-On Process; Example - Power Cycling Specific Outlets - LEGRAND Raritan PX3TS User Manual

Option Description
A range of Power cycles multiple, consecutive outlets.
outlets with a
For example, to specify 6 consecutive outlets -- 3, 4, 5,
hyphen in
6, 7, 8, type:
between
outlets 3-8.
If you entered the command without "/y", a message appears, prompting you
to confirm the operation. Then:
▪
Type y to confirm the operation, OR
▪
Type n to abort the operation
If you have configured outlet switching sequence and/or delay, PX3TS will
prompt you with one more question:
Should outlet sequence order and delays be used during
switching?
▪
Type y to apply the current outlet sequence and delay settings when
switching on outlets. See
Delay (on page 226).
▪
Type n to apply the default sequence and delays.

Canceling the Power-On Process

This section applies to outlet-switching capable models only.
After issuing the command to power on ALL outlets, you can use the following
command to stop the power-on process.
# power cancelSequence
To quicken the operation, you can add the parameter "/y" to the end of the
command, which confirms the operation.
# power cancelSequence /y

Example - Power Cycling Specific Outlets

The following command power cycles these outlets: 2, 6, 7, 8, 10, 13, 14, 15
and 16.
# power outlets 2,6-8,10,13-16 cycle
Chapter 9: Using the Command Line Interface
Setting Outlet Power-On Sequence and
701