LEGRAND Raritan PX3TS User Manual page 626

Chapter 9: Using the Command Line Interface
606
Customizing the Date and Time
To manually configure the date and time, use the following CLI commands to
specify them.
Note: You shall set the time configuration method to "manual" prior to
customizing the date and time. See
page 604).
Assign the date:
config:# time set date <yyyy-mm-dd>
Assign the time:
config:# time set time <hh:mm:ss>
Variables:
Variable Description
<yyyy-mm-dd> Type the date in the format of yyyy-mm-dd.
For example, type 2015-11-30 for November 30,
2015.
Type the time in the format of hh:mm:ss in the
<hh:mm:ss>
24-hour format.
For example, type 13:50:20 for 1:50:20 pm.
Setting the Time Zone
The CLI has a list of time zones to configure the date and time for PX3TS.
config:# time zone
After a list of time zones is displayed, type the index number of the time zone
or press Enter to cancel.
Example
To set the time zone:
1. Type the time zone command as shown below and press Enter.
config:# time zone
2. The system shows a list of time zones. Type the index number of the
desired time zone and press Enter.
Determining the Time Setup Method (on