LEGRAND Raritan PX3TS User Manual page 612

Chapter 9: Using the Command Line Interface
592
Option Description
false The network connection is NOT successfully established
when the TLS certificate chain contains any certificate
which is outdated or not valid yet.
•
<option3> is one of the options: true or false.
Option Description
true Make the network connection successful when the
PX3TS system time is earlier than the firmware build
before synchronizing with the NTP server, causing the
TLS certificate to become invalid.
false The network connection is NOT successfully established
when the PX3TS finds that the TLS certificate is not valid
due to incorrect system time.
•
<FQDN> is the name of the RADIUS server if it is present in the TLS
certificate. The name must match the fully qualified domain name (FQDN)
of the host shown in the certificate.
EAP CA Certificate Example
This section provides a CA certificate example for the Ethernet interface "ETH1".
Your CA certificate contents should be different from the contents displayed in
this example.
In addition, the procedure of uploading the client certificate and client private
key in CLI is similar to the following example, except for the CLI command.
To provide a CA certificate:
1. Make sure you have entered the configuration mode. See
Configuration Mode
2. Type the following command for ETH1 and press Enter.
config:# network ethernet eth1 eapCACertificate
3. The system prompts you to enter the contents of the CA certificate.
(on page 563).
Entering