LEGRAND Raritan PX3TS User Manual page 517

2. Click Edit Settings.
3. Enter a name for the webcam. Up to 64 ASCII printable characters are
supported.
▪
If configured to store snapshots on a remote server, the webcam's
name determines the name of the folder where snapshots are stored.
See Changing Storage Settings
Snapshots Folders on Remote Servers
▪
It is suggested to customize a webcam's name "prior to" saving
snapshots on the remote server. In case you change the webcam's
name after saving any snapshots, PX3TS will create a new folder with
the new webcam name while keeping the old folder with the old
name.
4. Type the location information in each location field as needed. Up to 63
ASCII printable characters are supported.
▪
Note that the location data you enter is not available in those
snapshots stored on remote servers.
Tip: If the webcam's location is important, you can customize the webcam's
name based on its location when configuring PX3TS to save snapshots onto
a remote server.
5. Select a resolution for the webcam.
▪
If you connect two webcams to one USB-A port using a powered USB
hub, set the resolution to 352x288 or lower for optimal performance.
6. Select the webcam mode.
Mode Description
The webcam enters the video mode.
Video
▪ Set the 'Framerate' (frames per second) as needed.
The webcam shows static images captured by the webcam
Snapshot
at a regular interval.
▪ To determine the interval, set the 'Time Between
Snapshots' (seconds) as needed.
7. Click Save. The changes made to the settings are applied to the live session
in the above Live Preview section immediately.
To return to the Webcam Management page:
•
Click Webcam Management on the top of the page.
•
Or click Webcams again in the
Chapter 7: Using the Web Interface
(on page 502) and Identifying
(on page 504).
Menu (on page 176).
497