Table of Contents
Advertisement
Before You Begin
•
The PX3TS previously obtained an IP address from the DHCP server, but
the lease of this IP address has expired, and the lease cannot be renewed,
or no new IP address is available.
Link-local addressing:
•
IPv4 address:
Factory default is to enable IPv4 only. The link-local IPv4 address is
169.254.x.x/16, which ranges between 169.254.1.0 and 169.254.254.255.
•
IPv6 address:
A link-local IPv6 address is available only after IPv6 is enabled on the PX3TS.
See
Configuring Network Settings
•
Host name - pdu.local:
You can type https://pdu.local to access the PX3TS instead of typing the
link-local IP address.
Retrieval of the link-local IPv4 address:
•
See
IPv4 Address
(on page 131).
Before beginning the installation, perform the following activities:
•
Unpack the product and components
•
Prepare the installation site
•
Check the branch circuit rating
•
Fill out the equipment setup worksheet
Unpacking the Product and Components
1.
Remove the PX3TS and other equipment from the box in which they were
shipped. See
Package Contents
contents of the box.
2.
Compare the serial number of the equipment with the number on the
packing slip located on the outside of the box and make sure they match.
3.
Inspect the equipment carefully. If any of the equipment is damaged or
missing, contact Raritan Technical Support Department for assistance.
4.
Verify that all circuit breakers on the PX3TS are set to ON. If not, turn them
ON.
Or make sure that all fuses are inserted and seated properly. If there are
any fuse covers, ensure that they are closed.
Preparing the Installation Site
1.
Make sure the installation area is clean and free of extreme temperatures
and humidity. See
Technical Specifications
(on page 310).
(on page 6) for a complete list of the
(on page 721).
Chapter 1: Introduction
7
Advertisement
Table of Contents
Troubleshooting
