Querying Available Parameters For A Command - LEGRAND Raritan PX3TS User Manual

Querying Available Parameters for a Command

If you are not sure what commands or parameters are available for a particular
type of CLI command or its syntax, you can have the CLI show them by adding a
space and the help command (?) or list command (ls) to the end of that
command. A list of available parameters and their descriptions will be
displayed.
The following shows a few query examples.
To query available parameters for the "show" command:
# show ?
To query available parameters for the "show user" command:
# show user ?
To query available role configuration parameters:
config:# role ?
To query available parameters for the "role create" command:
config:# role create ?
Tip: To automatically complete a command after typing part of the full
command, see Automatically Completing a Command
re-execute one of the previous commands, see
(on page 709).
Chapter 9: Using the Command Line Interface
(on page 709). To
Retrieving Previous Commands
529