LEGRAND Raritan PX3TS User Manual page 149

Outlet Information
The outlet mode is NOT available for PX3TS-1000 series.
The Outlet mode is displayed as "OUTLET" on the LCD display. By default the
PX3TS displays the current reading of OUTLET 1.
Below illustrates the outlet information shown on the LCD display.
Section Example information
The selected target is OUTLET 3.
This outlet's current reading is 2 amps.
"MASTER" indicates the PX3TS is the master device in a
cascading chain.
For a slave device, it shows "SLAVE" instead.
Note: "MASTER/SLAVE" information is only available in Port
Forwarding mode.
The measurement unit is A (Amp), indicating that the reading
is the RMS current.
To display a single-phase outlet's information:
1. By default this product enters the Outlet mode. If not, press the MODE
button until the word "OUTLET" is displayed.
2. In the Outlet mode, press the Up or Down button until the desired outlet's
number is displayed at the top of the LCD display.
3. Press the FUNC button to switch between voltage, active power and
current readings of the selected target.
▪
A is displayed for the current reading. A means Amp.
▪
V is displayed for the voltage reading. V means Volt.
▪
W is displayed for the power reading. W means Watt.
If the word "ALARM" appears below the reading, it means the currently
displayed reading already reaches or crosses the upper or lower
thresholds.
Chapter 6: Using the PX3TS
129