Logging Out Of Cli - LEGRAND Raritan PX3TS User Manual

Chapter 9: Using the Command Line Interface

Logging out of CLI

710
Examples:
•
Example 1 (only one possible command):
a. Type the first word and the first letter of the second word of the
"reset factorydefaults" command -- that is, reset f.
b. Then press Tab or Ctrl+i to complete the second word.
•
Example 2 (only one possible command):
a. Type the first word and initial letters of the second word of the
"security strongPasswords" command -- that is, security
str.
b. Then press Tab or Ctrl+i to complete the second word.
•
Example 3 (more than one possible commands):
Type only the first two words of the "network ipv4 gateway
a.
xxx.xxx.xxx.xxx" command -- that is, network ipv4.
b. Then press Tab or Ctrl+i one or two times, a list of possible commands
displays as shown below.
gateway
Type the full command "network ipv4 gateway
c.
xxx.xxx.xxx.xxx", according to the onscreen command list.
After completing your tasks using the CLI, always log out of the CLI to prevent
others from accessing the CLI.
To log out of the CLI:
1. Ensure you have entered administrator mode and the # prompt is
displayed.
Type exit and press Enter.
2.
interface staticRoutes