Table of Contents
Advertisement
Appendix K: Integration
Dominion KSX II, SX or SX II Configuration
872
3.
Click OK on the Power Off confirmation dialog. The outlet will be turned off
and its state will be displayed as 'off'.
To cycle the power of an outlet:
1.
Click Cycle next to the outlet you want to cycle. The Power Cycle Port
dialog opens.
2.
Click OK. The outlet will then cycle (note that this may take a few seconds).
3.
Once the cycling is complete the dialog will open. Click OK to close the
dialog.
Raritan PX3TS support the integration with Raritan's serial access products -
Dominion KSX II, Dominion SX and Dominion SX II.
Cables used for connecting the PX3TS to different Dominion access products
are different.
•
KSX II - a standard network patch cable (CAT5 or higher)
•
SX - a CSCSPCS cable
•
SX II - a CSCSPCS cable
Note: To only access the CLI of the PX3TS via SX / SX II, treat the PX3TS as a
serial device by connecting SX /SX II to the PDU's serial port instead of the
FEATURE port.
For more information on these Dominion serial access product, refer to:
•
KSX II, SX or SX II User Guide on the
(http://www.raritan.com/support/)
•
KSX II, SX or SX II Online Help on the
(http://www.raritan.com/support/online-help/)
Dominion KSX II
After connecting a Dominion KSX II to the Raritan PDU, you can monitor the
PDU and even control its outlets if the PDU is an outlet-switching capable
model.
Connecting a Rack PDU
To connect the Raritan PX to the KSX II:
1.
Connect one end of a Cat5 cable to the following ports of different Raritan
PX.
▪
PX1 series: RJ-45 "SERIAL" port
▪
PX2, PX3 or PX3TS series: RJ-45 "FEATURE" port
2.
Connect the other end of the Cat5 cable to either the Power Ctrl. 1 or
Power Ctrl. 2 ports on the back of the KSX II.
Support page
Product Online Help page
Advertisement
Table of Contents
Troubleshooting
