Table of Contents
Advertisement
Chapter 6: Using the PX3TS
138
Note: Press and hold the Up or Down button for at least two (2) seconds to
quickly move through several items at once.
▪
If the word "ALARM" appears below the rack unit number, it means no
asset tag is physically connected to that rack unit.
▪
If the word "ALARM" does NOT appear, it means a connected asset tag
is detected on the rack unit.
USB-Cascaded Device's Position
Note: As of release 3.3.10, the following cascading information is no longer
available in the Bridging mode, but remains available in the Port Forwarding
mode.
A cascaded device's position is available by operating the LCD display.
Below illustrates a slave device's position.
Section
Example information
"d" means the LCD display has entered the Device mode.
"CA" indicates that the cascading information is being
displayed.
"SLAVE" indicates that this PX3TS is a slave device.
Note: For a master device, it shows the word "MASTER"
instead.
The number 1 means the device position is Slave 1.
To retrieve the device's cascading position information:
1.
Press the MODE button to enter the Device mode, indicated by a 'd' in at
the top left of the display.
2.
Press the FUNC button until "CA" is displayed at the top right of the
display.
3.
The device's position is represented by any number defined below:
Advertisement
Table of Contents
Troubleshooting
