Snmp Gets And Sets; The Px3Ts Mib - LEGRAND Raritan PX3TS User Manual

SNMP Gets and Sets

In addition to sending notifications, the PX3TS is able to receive SNMP get and
set requests from third-party SNMP managers.
•
Get requests are used to retrieve information about the PX3TS, such as the
system location, and the current on a specific outlet.
•
Set requests are used to configure a subset of the information, such as the
SNMP system name.
Note: The SNMP system name is the PX3TS device name. When you change
the SNMP system name, the device name shown in the web interface is
also changed.
The PX3TS does NOT support configuring IPv6-related parameters using the
SNMP set requests.
Valid objects for these requests are limited to those found in the SNMP MIB-II
System Group and the custom PX3TS MIB.

The PX3TS MIB

The SNMP MIB file is required for using your PX3TS with an SNMP manager. An
SNMP MIB file describes the SNMP functions.
Chapter 8: Using SNMP
521