Table of Contents
Advertisement
▪
To retrieve the exact data at a particular time, hover your mouse over
the data line in the chart. Both the time and data are displayed as
illustrated below.
To configure this OCP's threshold settings:
By default, upper thresholds of an OCP's RMS current have been configured.
See
Default Voltage and Current Thresholds
them as needed.
Note: The threshold values set for an individual OCP will override the bulk
threshold values stored on that particular OCP. To configure thresholds for
multiple OCPs at a time, see
1.
Click the Thresholds title bar at the bottom of the page to display the
threshold data.
2.
Click the RMS current sensor (required), and then click Edit Thresholds.
3.
Make changes as needed.
▪
To enable any threshold, select the corresponding checkbox.
Chapter 7: Using the Web Interface
(on page 842). You can modify
OCPs
(on page 249).
253
Advertisement
Table of Contents
Troubleshooting
