Configuring Network Services - LEGRAND Raritan PX3TS User Manual

▪ You must disconnect the LAN cable and ALL cascading cables
connected to the two devices first before swapping them, and
then reconnecting all cables.
To change the cascading mode applied to a chain:
1. Access the last slave device, and change its cascading mode.
▪
If the new cascading mode is 'Port Forwarding', you must also set its
role to 'Slave'.
2. Access the second to last, third to last and so on until the first slave device
to change their cascading modes one by one.
3. Access the master device, and change its cascading mode.
▪
If the new cascading mode is 'Port Forwarding', you must also set its
role to 'Master', and correctly select the downstream interface.
The following diagram indicates the correct sequence. 'N' is the final one.
▪
M = Master device
▪
S = Slave device

Configuring Network Services

PX3TS supports the following network communication services.
Chapter 7: Using the Web Interface
337