LEGRAND Raritan PX3TS User Manual page 418

Chapter 7: Using the Web Interface
398
a. In the Available field, select desired methods one by one, or click
Select All. See step 3 for details.
b. In the Selected field, click any method's
ones, or click Deselect All.
Action Group
You can create an action group that performs up to 32 actions. After creating
such an action group, you can easily assign this set of actions to any event rule
rather than selecting all needed actions one by one per rule.
If the needed action is not available yet, create it first. See
(on page 394).
Operation:
1. Choose Device Settings > Event Rules >
2. Select 'Execute an action group' from the Action list.
3. To select any action(s), select them one by one from the 'Available actions'
list.
▪
To select all available actions, click Select All.
4. To remove any action(s) from the 'Selected actions' field, click that action's
.
▪
To remove all actions, click Deselect All.
Change Load Shedding State
The "Change load shedding state" action is available only when your PX3TS is
able to control outlet power. Use this action to activate or deactivate the load
shedding mode for responding to a specific event. For additional information,
see Load Shedding Mode
Operation:
1. Choose Device Settings > Event Rules >
2. Select 'Change load shedding state' from the Action list.
3. In the Operation field, select either one below:
▪
Start load shedding: Enters the load shedding mode when the specified
event occurs.
▪
Stop load shedding: Quits the load shedding mode when the specified
event occurs.
(on page 229).
to remove unnecessary
Available Actions
.
.