LEGRAND Raritan PX3TS User Manual page 759

Note: Each value in the file must be separated by an equal sign (=), without
any surrounding spaces.
•
Multi-line values are supported by using the Here Document Syntax with a
user-chosen delimiter.
The following illustration declares a value in two lines. You can replace the
delimiter EOF with other delimiter strings.
key<<EOF
value line 1
value line 2
EOF
Note: The line break before the closing EOF is not part of the value. If a line
break is required in the value, insert an additional empty line before the
closing EOF.
Special configuration keys:
There are 3 special configuration keys that are prefixed with magic:.
▪
A special key that sets a user account's password without knowing the
firmware's internal encryption/hashing algorithms is implemented.
Example:
magic:users[1].cleartext_password=joshua
▪
Two special keys that set the SNMPv3 passphrases without knowing
the firmware's internal encryption/hashing algorithms are
implemented.
Examples:
magic:users[1].snmp_v3.auth_phrase=swordfish
magic:users[1].snmp_v3.priv_phrase=opensesame
To configure device-specific settings:
1. Make sure the device list configuration file "devices.csv" is available in the
USB drive. See devices.csv
2. In the "config.txt" file, refer each device-specific configuration key to a
specific column in the "devices.csv" file. The syntax is: ${column}, where
"column" is a column number.
Examples:
net.interfaces[eth0].ipv4.static.addr_cidr.addr=${4
}
pdu.name=${16}
Appendix C: Configuration or Firmware Upgrade with a USB Drive
(on page 741)
739