Chapter 10 Using Scp Commands; Firmware Update Via Scp - LEGRAND Raritan PX3TS User Manual

Chapter 10

Firmware Update via SCP

Using SCP Commands
You can perform a Secure Copy (SCP) command to update the PX3TS firmware,
do bulk configuration, or back up and restore the configuration.
In This Chapter
Firmware Update via SCP ................................................................................. 711
Bulk Configuration via SCP ................................................................................ 712
Backup and Restore via SCP .............................................................................. 713
Downloading Diagnostic Data via SCP .............................................................. 714
Uploading or Downloading Raw Configuration Data ........................................ 716
Same as any PX3TS firmware update, all user management operations are
suspended and all login attempts fail during the SCP firmware update. For
details, see Updating the PX3TS Firmware
Warning: Do NOT perform the firmware upgrade over a wireless network
connection.
To update the firmware via SCP:
1. Type the following SCP command and press Enter.
scp <firmware file> <user name>@<device ip>:/fwupdate
▪
<firmware file> is the PX3TS firmware's filename. If the firmware file is
not in the current directory, you must include the path in the
filename.
▪
<user name> is the "admin" or any user profile with the Firmware
Update permission.
▪
<device ip> is the IP address or hostname of the PX3TS where you
want to upload the specified file.
2. Type the password when prompted, and press Enter.
3. The system transmits the specified firmware file to the PX3TS, and shows
the transmission speed and percentage.
4. When the transmission is complete, it shows the following message,
indicating that the PX3TS starts to update its firmware now. Wait until the
upgrade completes.
Starting firmware update. The connection will be closed
now.
(on page 474).
711