LEGRAND Raritan PX3TS User Manual page 894

Appendix K: Integration
PX appliance
SX II
874
Dominion SX II
The way to use Dominion SX II to configure and control a Raritan PDU is similar
to using Dominion KX III, but the connection method is different from KX III.
Note: If using a CSCSPCS-1 cable for the connection, it must be "Rev.0C". If using
a CSCSPCS-10 cable, it must be "Rev.0D".
Note that the appliances used in the diagram may not match your specific
models. However, the connections and ports used are the same across models.
To connect the SX II to the Feature port on the PX:
1. Connect the gray end of the CSCSPCS crossover Cat5 cable into the Feature
port on the PX.
2. Connect the yellow end of the CSCSPCS crossover Cat5 cable into a port on
the SX II.
3. Power on the PX (if it is not already).
4. You can now add the PX as a managed power strip to the SX II. See
Configure Power Strips from the Remote Console or Configure Power
Strips Using CLI. in the SX II User Guide or Online Help.