Table of Contents
Advertisement
Chapter 4: Connecting External Equipment (Optional)
56
Using an Optional DPX3-ENVHUB4 Sensor Hub
A Raritan DPX3-ENVHUB4 sensor hub is physically and functionally similar to
the DPX-ENVHUB4 sensor hub, which increases the number of sensor ports for
the PX3TS, except for the following differences:
•
All ports on the DPX3-ENVHUB4 sensor hub are RJ-45 instead of RJ-12 as
the DPX-ENVHUB4 sensor hub.
•
The DPX3-ENVHUB4 sensor hub supports all Raritan environmental sensor
packages, including DPX, DPX2, DPX3, DX and DX2 sensor packages.
To connect diverse types of sensor packages to this sensor hub, you must
follow the combinations shown in the section titled
Types
(on page 57).
To connect Raritan sensor packages via the DPX3-ENVHUB4 hub:
1.
Connect the DPX3-ENVHUB4 sensor hub to the PX3TS using a standard
network patch cable (CAT5e or higher).
a.
Plug one end of the cable into the IN port (Port 1) of the hub.
b. Plug the other end of the cable into the RJ-45 SENSOR port of the
PX3TS.
2.
Connect the Raritan sensor packages to any of the four OUT ports on the
hub.
▪
An RJ-12 to RJ-45 adapter is required for connecting a DPX or DPX2
sensor package to the hub.
This diagram illustrates a configuration with a sensor hub connected.
PX3TS
A standard network cable
Mixing Diverse Sensor
Advertisement
Table of Contents
Troubleshooting
