Table of Contents
Advertisement
Chapter 10: Using SCP Commands
Bulk Configuration via SCP
712
SCP example:
scp pdu-px2-030410-44599.bin
admin@192.168.87.50:/fwupdate
Windows PSCP command:
PSCP in Windows works in a similar way to the SCP.
▪
pscp <firmware file> <user name>@<device
ip>:/fwupdate
Like performing bulk configuration via the web interface, there are two steps
with the bulk configuration using the SCP commands:
a.
Save a configuration from a source PX3TS.
b. Copy the configuration file to one or multiple destination PX3TS.
For detailed information on the bulk configuration requirements, see
Configuration
(on page 479).
To save the configuration via SCP:
1.
Type the following SCP command and press Enter.
scp <user name>@<device ip>:/bulk_config.txt <filename>
▪
<user name> is the "admin" or any user profile with Administrator
Privileges.
▪
<device ip> is the IP address or hostname of the PX3TS whose
configuration you want to save.
▪
<filename> is the custom filename you assign to the "bulk_config.txt"
of the source PX3TS.
2.
Type the user password when prompted.
3.
The system saves the configuration from the PX3TS to a file named
"bulk_config.txt."
To copy the configuration via SCP:
1.
Type the following SCP command and press Enter.
scp bulk_config.txt <user name>@<device ip>:/bulk_restore
▪
<user name> is the "admin" or any user profile with Administrator
Privileges
▪
<device ip> is the IP address of the PX3TS whose configuration you
want to copy.
2.
Type the user password when prompted.
Bulk
Advertisement
Table of Contents
Troubleshooting
