Pdu - LEGRAND Raritan PX3TS User Manual

Chapter 7: Using the Web Interface

PDU

206
▪
Enter assertion times (seconds). See
Timeout (on page 837).
▪
Enter deassertion hysteresis values. To disable the deassertion
hysteresis, type 0 (zero). See
Hysteresis (on page 839).
Note: Any changes made to power quality thresholds will change the voltage
and frequency threshold values of both inlets. See
page 218).
Example:
If you set the voltage's Lower Critical to 70V and Lower Warning to 80V,
Inlet 1's power quality is shown as Critical when Inlet 1's voltage drops to
or lower than 70V, and Inlet 2's power quality is shown as Warning when
Inlet 2's voltage falls between 70V and 80V.
The PX3TS device's generic information and PDU settings are available on the
PDU page.
To open the PDU page, click 'PDU' in the
Device information shown:
•
Firmware version
•
Serial number
•
MAC address
•
Rating
•
Internal Beeper State
To configure global settings:
1. Click Edit Settings.
2. Now you can configure the fields.
"To Assert" and Assertion
"To De-assert" and Deassertion
Individual Inlet Pages
Menu (on page 176).
(on page 211)
(on