Table of Contents
Advertisement
External Beeper
This section applies to PX3 only.
If an external beeper is connected to the PX3TS, the PX3TS can change the
beeper's behavior or status to respond to a certain event.
To control the connected external beeper:
1.
Choose Device Settings > Event Rules >
2.
Select 'External beeper' from the Action list.
3.
In the 'Beeper port' field, select the port where the external beeper is
connected. This port is the FEATURE port.
4.
In the 'Beeper action' field, select an action for the external beeper to carry
out.
▪
Alarm: Causes the external beeper to sound an alarm cycle every 20
seconds - stays on for 0.7 seconds and then off for 19.3 seconds.
▪
On: Turns on the external beeper so that it buzzes continuously.
▪
Off: Turns off the external beeper so that it stops buzzing.
Warning: If you create an event rule for the external beeper but disconnect it
when an event causes it to beep, the beeper no longer beeps after it is
re-connected even though the event triggering the beeping action remains
asserted.
Internal Beeper
This section applies to PX3 only.
You can have the built-in beeper of the PX3TS turned on or off when a certain
event occurs.
Operation:
1.
Choose Device Settings > Event Rules >
2.
Select 'Internal beeper' from the Action list.
3.
Select an option from the Operation field.
▪
Turn beeper on: Turns on the internal beeper to make it buzz.
▪
Turn beeper off: Turns off the internal beeper to make it stop buzzing.
Chapter 7: Using the Web Interface
.
.
399
Advertisement
Table of Contents
Troubleshooting
