LEGRAND Raritan PX3TS User Manual page 873

•
Static IP configuration:
To set Use this command
network <ipvX> interface <ETH>
Static IPv4 or
address <ip address>
IPv6 address
<ip address> = static IP address, with a
syntax similar to the example below.
▪ Example: 192.168.7.9/24
network <ipvX> gateway <ip
Static IPv4 or
address>
IPv6 gateway
<ip address> = gateway's IP address
network dns firstServer <ip
IPv4 or IPv6
address>
primary DNS
server
<ip address> = DNS server's IP address
network dns secondServer <ip
IPv4 or IPv6
address>
secondary DNS
server
<ip address> = DNS server's IP address
network dns thirdServer <ip
IPv4 or IPv6
address>
third DNS
server
<ip address> = DNS server's IP address
Commands for "Ethernet" authentication method:
To set or Use this command
enable
network ethernet <ETH>
Authentication
authMethod <method>
method
<method> = none or eap
network ethernet <ETH>
EAP outer
eapOuterAuthentication
authentication
<outer_auth>
<outer_auth> = PEAP or TLS
network ethernet <ETH>
EAP inner
eapInnerAuthentication
authentication
<inner_auth>
<inner_auth> = MSCHAPv2 or TLS
Appendix J: Additional PX3TS Information
853