LEGRAND Raritan PX3TS User Manual page 708

Chapter 9: Using the Command Line Interface
688
Specifying the Rack Unit Numbering Mode
This command syntax specifies the numbering mode of rack units on the asset
strips connected to the PX3TS device. The numbering mode changes the rack
unit numbers.
config:# assetStrip <n> rackUnitNumberingMode <mode>
Variables:
•
<n> is the number of the FEATURE port where the selected asset strip is
physically connected. For the PX3TS device with only one FEATURE port,
the number is always 1.
•
<mode> is one of the numbering modes: topDown or bottomUp.
Mode Description
topDown The rack units are numbered in the ascending order
from the highest to the lowest rack unit.
bottomUp The rack units are numbered in the descending order
from the highest to the lowest rack unit.
Specifying the Rack Unit Numbering Offset
This command syntax specifies the starting number of rack units on the asset
strips connected to the PX3TS device.
config:# assetStrip <n> rackUnitNumberingOffset <number>
Variables:
•
<n> is the number of the FEATURE port where the selected asset strip is
physically connected. For the PX3TS device with only one FEATURE port,
the number is always 1.
•
<number> is a starting number for numbering rack units on the connected
asset strip. This value is an integer number.