LEGRAND Raritan PX3TS User Manual page 610

Chapter 9: Using the Command Line Interface
590
Setting Wireless EAP Parameters
When the wireless authentication method is set to EAP, you must configure
EAP authentication parameters, including outer authentication, inner
authentication, EAP identity, client certificate, client private key, password, CA
certificate, and RADIUS authentication server. For more information, see
Wireless Network Settings
Determine the outer authentication protocol:
config:# network wireless eapOuterAuthentication <outer_auth>
Determine the inner authentication protocol for authentication set to
"EAP + PEAP":
config:# network wireless eapInnerAuthentication <inner_auth>
Set the EAP identity:
config:# network wireless eapIdentity <identity>
Set the EAP password:
config:# network wireless eapPassword
After performing the above command, the PX3TS prompts you to enter the
password. Then type the password and press Enter.
Provide a Client Certificate for authentication set to "EAP + TLS" or "EAP
+ PEAP + TLS":
config:# network wireless eapClientCertificate
After performing any certificate or private key commands, including commands
for the client certificate, client private key, and CA certificate, the system
prompts you to enter the contents of the wanted certificate or key. For an
example with detailed procedure, see
592).
Provide a Client Private Key for authentication set to "EAP + TLS" or "EAP
+ PEAP + TLS":
config:# network wireless eapClientPrivateKey
Provide a CA TLS certificate for EAP:
config:# network wireless eapCACertificate
Eable or disable verification of the TLS certificate chain:
config:# network wireless enableCertVerification <option1>
(on page 317).
EAP CA Certificate Example (on page