LEGRAND Raritan PX3TS User Manual page 151

▪
OPEN: The selected circuit breaker is open, or the selected fuse has
burned out. When this occurs, the term CbE is displayed in place of
the reading and a blinking word "ALARM" appears next to the word
OPEN.
IPv4 Address
The IP address is available in the Device mode, which is indicated by the
alphabet 'd' shown at the top of the LCD display. Note that this type of LCD
display only shows the IPv4 address (if available).
Below illustrates the IP address information.
Section Example information
"d" means the LCD display has entered the Device
mode.
The LCD display is showing 192, which is one of the
four IP address octets. It will cycle through four octets.
"i4" indicates that the IP address shown on the LCD
display is an IPv4 address.
"MASTER" indicates the PX3TS is the master device in a
cascading chain.
For a slave device, it shows "SLAVE" instead.
Note: "MASTER/SLAVE" information is only available in
Port Forwarding mode.
If you connect your PX3TS to the wireless network, a Wi-Fi icon is displayed at
the bottom-right corner.
Chapter 6: Using the PX3TS
131