Miscellaneous - LEGRAND Raritan PX3TS User Manual

Chapter 7: Using the Web Interface
462
4. Make changes to the information shown, except for the script's name,
which cannot be revised.
▪
To replace the current script, click Load Local File or Load Example to
select a new script.
To delete a script:
1. Choose Device Settings > Lua Scripts.
2. Click the desired one in the scripts list.
3. Click > Delete.
4. Click Delete on the confirmation message.
To return to the scripts list:
•
Click "Lua Scripts" on the top of the page.
•
Or click "Lua Scripts" in the

Miscellaneous

By default, the Schroff LHX/SHX heat exchanger support and Cisco EnergyWise
feature implemented on the PX3TS are disabled.
Support needs to be enabled for the LHX/SHX information to appear in the
PX3TS web interface. Besides, Schroff LHX/SHX support must be enabled in
order for the LHX-MIB to be accessible through SNMP.
If a Cisco EnergyWise energy management architecture is implemented in your
®
place, you can enable the Cisco EnergyWise endpoint implemented on the
PX3TS so that this PX3TS becomes part of the Cisco EnergyWise domain.
In addition, if you have to prevent others from accessing your PX3TS via USB-A
for security reasons, you can disable all of USB-A ports on the PX3TS. By default,
USB-A ports are enabled.
Important: Disabling USB-A ports will disable all of 'USB-A' based features,
such as wireless networking, USB cascading or pdView access using iOS
mobile devices. Therefore, re-think about it before disabling USB-A.
To configure any of the above features, choose Device Settings >
Miscellaneous.
To enable the support for Schroff LHX/SHX:
1. Select the LHX/SHX checkbox.
2. Click Save in the Features section.
3. Click Apply on the confirmation message.
4. PX3TS reboots.
Menu (on page 176).