LEGRAND Raritan PX3TS User Manual page 153

For example, if the MAC address is 00:0d:5d:03:5E:1A, the LCD display
shows the following information one after another:
M 00 --> M:0d --> M:5d --> M:03 --> M:5E --> M:1A
Note that 'M' is NOT followed by the colon symbol when showing the first
two digits of the MAC address.
Environmental Sensor Information
The environmental sensor mode is displayed as "SENSOR" on the LCD display.
Basic information about a specific environmental sensor is available, including
the sensor's reading or state, X, Y, Z coordinates and its serial number.
Below illustrates the environmental sensor information.
Number Example information
The selected target is the environmental sensor whose ID
number is 9 (SENSOR 9).
The selected environmental sensor's reading is 22
"MASTER" indicates the PX3TS is the master device in a
cascading chain.
For a slave device, it shows "SLAVE" instead.
Note: "MASTER/SLAVE" information is only available in Port
Forwarding mode.
The measurement unit is
To display the environmental sensor information:
1. Press the MODE button until this product enters the Sensor mode, as
indicated by "SENSOR" at the top of the LCD display.
2. Press the Up or Down button until the desired environmental sensor's ID
number is displayed.
3. For example, "SENSOR 1" refers to the sensor #1 listed on the PX3TS web
interface.
4. The LCD display shows the reading or state of the selected sensor in the
middle of the LCD display.
Chapter 6: Using the PX3TS
.
(degrees in Celsius).
133