Table of Contents
Advertisement
Chapter 9: Using the Command Line Interface
534
Interface
Description
eth1
Show the IPv4 or IPv6 configuration of the ETH1
interface.
eth2
Show the IPv4 or IPv6 configuration of the ETH2
interface.
wireless
Show the IPv4 or IPv6 configuration of the WIRELESS
interface.
bridge
Show the IPv4 or IPv6 configuration of the BRIDGE
interface.
all
Show the IPv4 or IPv6 configuration of all interfaces.
Tip: You can also type the command without adding
this option "all" to get the same data. That is, show
network ipv4 interface.
Network Interface Settings
This command shows the specified network interface's information which is
NOT related to IP configuration. For example, the Ethernet port's LAN interface
speed and duplex mode, or the wireless interface's SSID parameter and
authentication protocol.
#
show network interface <ETH>
Variables:
•
<ETH> is one of the network interfaces: ETH1/ETH2, WIRELESS, or BRIDGE.
Note that you must choose/configure the bridge interface if your PX3TS is
set to the bridging mode.
Note: In the bridging mode, only the IP parameters of the BRIDGE interface
function. The IP parameters of ETH1/ETH2 and WIRELESS interfaces do NOT
function.
Interface
Description
eth1
Show the ETH1 interface's non-IP settings.
eth2
Show the ETH2 interface's non-IP settings.
wireless
Show the WIRELESS interface's non-IP settings.
bridge
Show the BRIDGE interface's non-IP settings.
Advertisement
Table of Contents
Troubleshooting
