Clearing Diagnostic Log For Network Connections; Entering Configuration Mode - LEGRAND Raritan PX3TS User Manual

Entering Configuration Mode

Clearing Diagnostic Log for Network Connections

This command removes all data from the diagnostic log for both the EAP
authentication and WLAN connection.
# clear networkDiagLog
-- OR --
# clear networkDiagLog /y
If you entered the command without "/y," a message appears, prompting you
to confirm the operation. Type y to clear the log or n to abort the operation.
Configuration commands function in configuration mode only.
To enter configuration mode:
1. Ensure you have entered administrator mode and the # prompt is
displayed.
Note: If you enter configuration mode from user mode, you may have
limited permissions to make configuration changes. See
Modes and Prompts
Type config and press Enter.
2.
3. The config:# prompt appears, indicating that you have entered
configuration mode.
4. Now you can type any configuration command and press Enter to change
the settings.
Important: To apply new configuration settings, you must issue the "apply"
command before closing the terminal emulation program. Closing the
program does not save any configuration changes. See Quitting Configuration
Mode (on page 564).
Chapter 9: Using the Command Line Interface
(on page 527).
Different CLI
563