LEGRAND Raritan PX3TS User Manual page 34

Chapter 3: Initial Installation and Configuration
14
The "green" Ethernet port labeled "ETH 10/100/1000" supports up to
1000 Mbps so it is highly recommended for network connection. To make
a wired connection:
1. Connect a standard network patch cable to either or both Ethernet ports
on the PX3TS.
▪
The two Ethernet ports must be connected to different subnets. See
Dual Ethernet Connection
The "green" Ethernet port labeled "ETH 10/100/1000" supports up to 1000
Mbps so it is highly recommended for network connection.
Below illustrates the ETHERNET port(s) on different product models.
▪ PX3TS models:
▪ PX3TS-iX7 models:
Warning: Accidentally plugging an RS-232 RJ-45 connector into the Ethernet
port can cause permanent damage(s) to the Ethernet hardware.
To make a wireless connection:
Do one of the following:
▪
Plug a supported USB wireless LAN adapter into the USB-A port on
your PX3TS.
(on page 16).