Table of Contents
Advertisement
Interface
Description
all
Show the IP-related configuration of all interfaces.
Tip: You can also type the command without adding
this option "all" to get the same data. That is, show
network ip interface.
IPv4-Only or IPv6-Only Configuration
To show IPv4-only or IPv6-only configuration, use any of the following
commands.
Tip: To show both IPv4 and IPv6 configuration data, see
page 532).
To show IPv4 settings shared by all network interfaces, such as DNS and
routes:
#
show network ipv4 common
To show IPv6 settings shared by all network interfaces, such as DNS and
routes:
#
show network ipv6 common
To show the IPv4 configuration of a specific network interface:
#
show network ipv4 interface <ETH>
To show the IPv6 configuration of a specific network interface:
#
show network ipv6 interface <ETH>
Variables:
•
<ETH> is one of the network interfaces: ETH1/ETH2, WIRELESS, or BRIDGE.
Note that you must choose/configure the bridge interface if your PX3TS is
set to the bridging mode.
Note: In the bridging mode, only the IP parameters of the BRIDGE interface
function. The IP parameters of ETH1/ETH2 and WIRELESS interfaces do NOT
function.
Chapter 9: Using the Command Line Interface
IP Configuration
(on
533
Advertisement
Table of Contents
Troubleshooting
