Operation; Power On - LEGRAND Raritan RSS4-102 Administrator's Manual

Operation

In This Chapter

Power ON.................................................................................................................. 12

Manual Switching......................................................................................................13
LED Indicators........................................................................................................... 13
Chassis Intrusion Detection.......................................................................................14
Power ON
When you power on, reset, or power cycle the Secure Switch, the Secure Switch will perform a self-test
on the following items to check the device's integrity and security functions.
•
Firmware integrity
•
Accessibility of internal memory of the micro-controller
•
Key stuck test
•
Anti-tampering test
•
Port isolation test
▶
Self-test process:
•
All Port LEDs will turn ON and then OFF one by one.
•
When the self-test completes successfully, it will switch to Port 1, with the Port 1's LED turning
GREEN.
▶
Self-test failure:
In case of self-test failure, the Secure Switch becomes inoperable, with the port LED(s) flashing, which
indicates a potential cause to the failure.
•
The pre-defined port LED status indicates the failure cause.
• Button jammed: The port LED of a jammed button will flash green.
•
When all port LEDs flash, it means the KVM tampering is detected or there is an integrity issue.
For security, the Secure Switch becomes inoperable after self test fails.
Please verify your KVM installation, pushbuttons, and then power cycle the Secure Switch. If the self-
test failure remains, stop using the Secure Switch, remove it from service and contact your Raritan
reseller.
12