LEGRAND Raritan PX3TS User Manual page 45

2. Connect the other end to your computer's RS-232 port (COM).
3. Perform Initial Network Configuration via CLI
Serial connection for "RJ-45" RS-232 connector:
1. Connect the RJ-45 end of the RJ45-to-DB9 adapter cable to the RJ-45 port
labeled CONSOLE / MODEM on PX3TS.
▪
See RJ45-to-DB9 Cable Requirements for Computer Connections
page 25).
2. Connect the DB9 end to your computer's RS-232 port (COM).
See RJ45-to-DB9 Cable Requirements for Computer Connections
25).
3. Perform Initial Network Configuration via CLI
RJ45-to-DB9 Cable Requirements for Computer Connections
An RJ45-to-DB9 adapter/cable is required for connecting the PX3TS to a
computer, if the use of a USB cable is not wanted.
A third party RJ45-to-DB9 adapter/cable needs to meet the following
requirements.
•
RJ-45 to "DB9 female"
•
RX/TX and according control pins are CROSSED
The widespread blue Cisco RJ-45 to DB9 adapter cable is highly recommended,
which has the following pin assignments:
DB9 pin signal DB9 pin No.
CTS 8
DSR 6
RxD 2
GND 5
GND 5
TxD 3
DTR 4
RTS 7
DCD 1 (Not connected)
RI 9 (Not connected)
Note: The blue Cisco RJ-45 to DB9 adapter cable CANNOT be used for
connecting a modem. See
Connections (on page 830).
Chapter 3: Initial Installation and Configuration
RJ-45 pin No.
1
2
3
4
5
6
7
8
RJ45-to-DB9 Cable Requirements for Modem
(on page 851).
(on
(on page
(on page 851).
RJ-45 pin signal
RTS
DTR
TxD
GND
GND
RxD
DSR
CTS
N/A
25