LEGRAND Raritan PX3TS User Manual page 160

Chapter 6: Using the PX3TS
140
Automatic and Manual Modes
After powering on or resetting the PX3TS, the front panel LCD display first
shows some dots, then Raritan logo and finally enters the automatic mode.
Automatic mode without alerts available:
In this mode, the LCD display cycles through the transfer switch/inlet
information as long as there are no alerts.
If overcurrent protectors are available on your PX3TS, the display cycles
between both the transfer switch/inlet and overcurrent protector information.
Note: You can make a PX3TS with overcurrent protectors show the inlet
information only in the automatic mode. See
454).
Manual mode:
To view more information or control outlets if your PX3TS is outlet-switching
capable, enter the manual mode.
Press or to enter the manual mode, where the Main Menu is first
displayed. See Main Menu
To return to the automatic mode, press
When an alert exists:
•
In the automatic mode, when an alert occurs, the LCD display stops cycling
through information, and warns you by showing the alerts notice in a
yellow or red background. See
page 160).
To enter the manual mode, press
•
In the manual mode, both the top and bottom bars will turn yellow or red
to indicate the presence of any alert. See
Display (on page 142).
Front Panel Settings
(on page 143).
once or multiple times.
Alerts Notice in a Yellow or Red Screen
.
Operating the Dot-Matrix LCD
(on page
(on