LEGRAND Raritan PX3TS User Manual page 677

config:#
authentication ldap modify <server_num> "parameters"
Modifying an Existing LDAP Server
You can modify one or multiple parameters of an existing LDAP server, such as
its IP address, TCP port number, Base DN and so on. Besides, you can also
change the priority or sequence of existing LDAP servers in the server list.
Command syntax:
A command to modify an existing LDAP server's settings looks like the
following:
Variables:
•
<server_num> is the sequential number of the specified server in the LDAP
server list.
•
Replace "parameters" with one or multiple commands in the following
table, depending on which parameter(s) you want to modify.
A list of "parameters":
Chapter 9: Using the Command Line Interface
657