LEGRAND Raritan PX3TS User Manual page 348

Chapter 7: Using the Web Interface
328
Interface list:
Interface name
BRIDGE
ETH1
ETH2
WIRELESS
Setting the Cascading Mode
A maximum of 16 PX3TS devices can be cascaded to share one Ethernet
connection. See Cascading Multiple PX3TS Devices for Sharing Ethernet
Connectivity (on page 27).
The cascading mode configured on the master device determines the Ethernet
sharing method, which is either network bridging or port forwarding. See
Overview of the Cascading Modes
The cascading mode of all devices in the chain must be the same.
Only a user with the Change Network Settings permission can configure the
cascading mode.
Note: PX3TS in the Port Forwarding mode does not support APIPA. See
and Link-Local Addressing
To configure the cascading mode:
1. Connect the device you will cascade to the LAN and find its IP address, or
connect it to a computer.
▪
For computer connection instructions, see
Computer (on page 23).
▪
To find the IP address, see
2. Log in to its web interface. See
3. Choose Device Settings > Network.
4. Select the preferred mode in the Cascading Mode field.
Description
When another wired network is connected to the
Ethernet port of your PX3TS, and your PX3TS has been
set to the bridging mode, select this interface name
instead of the Ethernet interface.
When another wired network is connected to the
ETH1 port of your PX3TS, select this interface name.
When another wired network is connected to the
ETH2 port of your PX3TS, select this interface name.
When another wireless network is connected to your
PX3TS, select this interface name.
(on page 330).
(on page 6).
Connecting the PX3TS to a
Device Info (on page 155).
Login (on page 170).
APIPA