Bulk Configuration Methods - LEGRAND Raritan PX3TS User Manual

Chapter 3: Initial Installation and Configuration

Bulk Configuration Methods

26
If you have to set up multiple PX3TS devices, you can use one of the following
configuration methods to save your time.
A bulk configuration file downloaded from PX3TS:
•
Requirement: All PX3TS devices to configure are of the same model and
firmware.
•
Procedure: First finish configuring one PX3TS. Then download the bulk
configuration file from it and copy this file to all of the other PX3TS
devices.
See Bulk Configuration
A TFTP server:
•
Requirement: DHCP is enabled in your network and a TFTP server is
available.
•
Procedure: Prepare special configuration files, which must include
fwupdate.cfg, and copy them to the root directory of the TFTP server.
Re-boot all PX3TS devices after connecting them to the network.
See Bulk Configuration or Firmware Upgrade via DHCP/TFTP
746).
Curl command:
•
Requirement: Two files are required -- one is a configuration file in TXT and
the other is a devices list file in CSV. See
devices.csv (on page 741).
•
Procedure: Upload both files to all of PX3TS devices one by one, using the
appropriate curl command.
See Upload via Curl (on page 772).
SCP or PSCP command:
•
Requirement: Two files are required -- one is a configuration file in TXT and
the other is a devices list file in CSV.
•
Procedure: Upload both files to all of PX3TS devices one by one, using the
appropriate SCP or PSCP command.
See Uploading or Downloading Raw Configuration Data
(on page 479).
config.txt
(on page
(on page 738) and
(on page 716).