Table of Contents
Advertisement
Quick Links
Specifications
Voltages . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .120VAC, 60Hz
Maximum Load Rating . . . . . . . . . . . . . . . . . . . . . . . . . . . 800W
Load Type Compatibility . . . . . . . . . . . . . . . . . . . . . . .0 to 800W
Non-dimmable fluorescent ballasts
Discharge lighting fixtures
Fixtures with integral dimmers
AC motors and pumps
LightSense
PSWS
Wireless Switch
™
U.S. Patent 5,804,991.
Other patents pending
800.223.4185
Syracuse, NY 13221-4822
www.passandseymour.com
Advertisement
Table of Contents
Related Manuals for LEGRAND pass & seymour LightSense PSWS
Summary of Contents for LEGRAND pass & seymour LightSense PSWS
- Page 1 PSWS LightSense Wireless Switch ™ Specifications Voltages ....... .120VAC, 60Hz Maximum Load Rating .
-
Page 2: Unit Description
UNIT DESCRIPTION The LightSense™ Wireless PSWS Switch incorporates an electro-mechanical relay that switches the load safely using patented zero-crossing technology. LightSense Wireless LightSense wireless devices use radio signals to communicate with each other to control lighting and other types of electric loads in selected areas. LightSense wireless devices use the 900MHz band for high-speed control communication. -
Page 3: Installation
TURN THE POWER OFF AT THE CIRCUIT BREAKER BEFORE INSTALLING THE DEVICE. INSTALLATION For ease of installation, Pass & Seymour/Legrand recommends use of a deep wall box. 1. Disconnect power to circuit by turning circuit breaker OFF before installation. 2. Remove the existing wall plate and switch, if one is present. -
Page 4: New Installation
SET HOUSE ID New Installation All LightSense™ wireless devices installed in the same home must acquire the same unique House ID before use. This process is known as house binding. Each LightSense wireless device is bound to all other LightSense wireless devices in the house. -
Page 5: Operation
OPERATION Tap once Turn circuit ON – – Press and hold Turn circuit ON Tap once Turn circuit OFF – – Press and hold Turn circuit OFF When you see When you see in the in the instructions, instructions, touch the top touch the of the switch bottom of the... -
Page 6: Advanced Operation
ADVANCED OPERATION Groups Use a LightSense™ Wireless PSWS Switch in conjunction with one or more LightSense Wireless PSWCS Multilocation Controllers to control one non- dimmable lighting circuit from multiple locations. Binding the PSWS and PSWCS devices together in the same Group enables them to work in exactly the same way, from any control location. -
Page 7: Troubleshooting
CLEANING Clean using a cloth dampened only with water and a little mild detergent. Use of solvents or hydrocarbon-based cleaners may cause permanent damage. TROUBLESHOOTING During Set House ID, the LED is not flashing on some LightSense™ wireless devices. • If LED is solid green before initiating house ID binding: The device already has another house ID. -
Page 8: Fcc Notice
• Consult the dealer or an experienced radio/TV technician for help. Caution: Any changes or modifications to this device not explicitly approved by Pass & Seymour/Legrand could void your authority to operate this equipment. LIMITED FIVE YEAR WARRANTY Pass & Seymour will remedy any defect in workmanship or material in Pass & Seymour products which may develop under proper and normal use within five years from date of purchase by a consumer: (1) by repair or replacement, or, at Pass &...